PG-65
Rubber spring KR type
| Product Code | Note | ||
|---|---|---|---|
| PG-65 KR240-400 | Rubber spring KR type | ||
| PG-65 KR240-300 | Rubber spring KR type | ||
| PG-65 KR200-285 | Rubber spring KR type | ||
| PG-65 KR200-240 | Rubber spring KR type | ||
| PG-65 KR200-200 | Rubber spring KR type | ||
| PG-65 KR170-450 | Rubber spring KR type | ||
| PG-65 KR155-360-155H | Rubber spring KR type | ||
| PG-65 KR155-300-155H | Rubber spring KR type | ||
| PG-65 KR155-250-155H | Rubber spring KR type | ||
| PG-65 KR155-200 | Rubber spring KR type | ||
| PG-65 KR155-150 | Rubber spring KR type | ||
| PG-65 KR133-150 | Rubber spring KR type | ||
| PG-65 KR133-125 | Rubber spring KR type | ||
| PG-65 KR133-100 | Rubber spring KR type | ||
| PG-65 KR120-90 | Rubber spring KR type | ||
| PG-65 KR120-60 | Rubber spring KR type | ||
| PG-65 KR90-150 | Rubber spring KR type | ||
| PG-65 KR90-125 | Rubber spring KR type |
| Materials | Synthetic Rubber |
|---|---|
| Finish | Black |
| Usage examples | Vibration sieve, Vibration conveyor, Part feeder |
| Operating instructions | For installation, place the guide pin on the inner face of the rubber spring and set the machine on top of it. When the inner diameter is too large, use a spacer separately.（ When applying a spacer, do not push the spacer with the guide） |
| Attention | ◇Spacer is not attached. ◇After tapering the mount giude, make a radius at the end of it. ◇If the vibration frequency is higher than 20Hz or the amplitude is longer than 14mm, the material needs to be a natural rubber which cuases less heat. ・The ambient temperature must be between -10〜50℃. ◇Under proper usage, the external inflation is approximately 5% of the outer diameter. |
Features
-
・Vibration quickly settles due to the effective damping control.
・Achieved removing the microvibration of light weight items
・Excellent resitance against low and high temperatures, allowing to use under a wide range of temperature conditions（-30〜150℃）
・Excellent weather resistance and electrical insulation